Got some more ORGS & JKS parts today.
ORGS raised rear shock mounts for the rear axle (I get hung up on my current ones because they hang too low. I mangled them up pretty good.)
ORGS 2″ raised swaybar mounts
JKS bar pin eliminators for the front shocks (will give my shocks another 1/2 inch of down travel)
I got my Rubicon Express 4* Steel Shims finally installed! I finally have a vibration free driveline!
Sorry, no pics. Too hot out.
Today I cleaned the whole floor down with marine clean
then went over the new sheet metal and surface rusted areas with por-15
All i have left to do is mask off the areas I don’t want Herculiner, scuff up the floor, and roll on the Herculiner.
A few pictures from today. I didn’t get very far because my angle grinder stopped working on me. I think it’s the switch….I’ll be bringing it back to Sears Hardware tonight for a replacement.
the hole i was patching.
sheet metal cut to size
still not as pretty as I’d like. but i layed some better beads this time around
I just need to get my new angle grinder so i can grind down those welds…then i can finish repairing the last hole.
Then it’s time for the Herculiner
I started today off by relocating my front brake lines for more travel
Then I went on to start repairing the holes in the floor
Piece of sheet metal cut to size
my welding sure ain’t pretty, but it’s definitely gonna hold
then I used some POR-15 to cover it up
